|
Welcome to ceiling Fans Forums
Friday, February 10, 2012 |
| Ceiling Fan Help \ Ceiling Fan Problems \ Hard Wiring Built-In Remote | ||||||
| Robert Posted on 3/28/2009 3:24:09 PM | ||||||
| I have a Hampton Bay Ainsley fan. It has no pull chains and is controlled by a Rhine UC7058RY built-in fan speed control. For many reasons I would like to somehow remove this control and control the lights and fan speeds through a wall mounted switch for the lights and a wall mounted simple low-medium-high-off control. I do realize that the start capacitor(s) and possibly other components for correct motor operation are contained in the existing control. I am an experienced electronic technician and could build anything required but am at a loss on how to do this without a schematic diagram of the control. Since I believe that many others would like to do the same, could you possibly help with any advice, wiring information, conversion schematic, etc. | ||||||
| cfanrepair Posted on 4/1/2009 8:03:34 PM | ||||||
|
Sorry, you will have to reverse engineer it. How many wires does the receiver have? |
||||||
88 Guests Online and 9 Users OnlineCopyright (R) 2006-2012 to ceiling Fan Forums. All rights reserved.
Spread the word out about "Ceiling Fans 'N More Forums" by Tell a Friend! feature.
Casablanca Ceiling Fans | Rustic Ceiling Fans | Content Management