I just installed a Minka Aire Napoli with remote. The receiver in the fan gets power. I did NOT hook up the wall switch (no access to the wires from a switch). Following the programming instructions, I tried several codes but no matter what code I try on the remote, it doesn't control the fan.
Any ideas? Mike
|
1. How did you wire it
2. What type of switch is it, just a regular on off?
3. What was there before the fan and how was it wired?
|
Fan with pull chain was there before. The box in the ceiling has hot, neutral and ground. There is no wall switch.
The remote receiver has a black & white on one side and a black, white & blue on the other.
I wired hot & neutral to the black & white on the one side. I wired black, white & blue to black, white & blue on the fan.
I tried several times to 'program' the receiver by holding the stop button down for 3 seconds within 60 of turning on the breaker. There are no dip switches on this model receiver.
|
Try wiring the fan without the receiver and see what happens.
Also, make sure the dip switches in the fan and remote match.
|
Issue may be solved:
The remote sold to me with the fan is not the correct one. The RC210 remote that I have now is for the black, dip switched receiver. The RC212 remote that I will be swapping for tonight is for the green, non-dip switched receiver.
Check your remote/receiver compatibility at time of purchase. The green receiver is fairly new and the remotes may be harder to come by just now. Mike
|
|
That was the problem. The new remote programs the receiver as expected and the fan & light work beautifully.
|
|
Glad you got it working.
|